If it is plastic, there is probably not much you can do besides order a new one. They are actually fairly easy to install, provided you can disconnect the power to the machine first, and have needle nose pliers for disconnecting the wires.

If you only know the volume, you can't.

You need to know a couple things... The volume and the height for example.

The volume is equal to the area of the base multiplied by the height, so if you have the volume and the height you get

V (volume) = A … Read more

As Sunyday says, so what? Clearly there are verses that condemn homosexuality in the Bible, but there are also verses that condemn eating crustaceans, and tell us that we should stone prostitutes to death.

Reading the Bible is one of those things that people do selectively. Things that are inconvenient for people to follow … Read more

Don't paint the gravestone. Paint doesn't stick well to stone, and in a few years it will be all peeled and awful looking. Plus, the managers of the graveyard may not bee too keen on the idea either.

When you say it does not shut off or fill up, do you mean that it makes a buzz noise but never fills?

If it makes a buzz noise, but no water comes into the machine, you most likely have one of two problems.

1. The water is shut off at the wall … Read more

If it's a gas dryer, (and the vent is clear) you have one of two parts bad—the igniter, or the valve coils. Both are easy to replace, and if your dryer is older, you might want to replace them both, since they have about the same lifespan.

When the coils (they are not heaters, … Read more

It means that if you sew up a hole when it is smaller it will take one stitch, but if you wait until the hole is bigger, it will take 10 stitches. By sewing the stitch "in time" it will save you nine stitches.

It applies to lots of things situations.

Absolutely! You need to make sure that the plywood is plenty thick and sturdy (like maybe 3/4"), and most of all, flat. If the plywood is going to have any tendency to bend even slightly, the tiles may start to come loose.

the flatter and sturdier the plywood is, the better your results will be.

My guess is that it would be 30 yards long

You are going to have to open it up to find out where the leak is. It sounds like the fill meter hose has come off. How you get into the machine depends on what brand it is, so you might want to post another question to ask "how do I open the cabinet of … Read more